Plus42 Equations, Preview Release

[Marco Polo]

(05-01-2022 11:25 AM)Thomas Okken Wrote:  Once a value has been populated with a unit, you can then assign new values without a unit, and the existing unit will be applied to the new value. It sounds like that's what you're asking, but if it isn't, could you give the exact sequence of keystrokes that you would like to use? Because I'm not sure I understand the problem.

1) select equation
2) CALC
3) I would like to find the all the variable inizialized with a default value (i.e. 0_unit or whatever) according to a definition inside the equation itself.

Example
Equation X/Y=Z
Default values: X=1_bar Y=1_m Z=1_bar/m

I am looking for a way to define this into an equation, so that I don't have to input the units if the variables do non exist from a previous calculation