Post Reply 
HP41C keyboard label remove
05-15-2015, 10:31 AM
Post: #1
HP41C keyboard label remove
Hi,
is there any succesful way to remove the keyboard label of an HP41C?
I have got one in bad state that could be replaced from a donor.
Maybe heating with a hairdryer would help? Do you have any experience?

Thanks in advance

Kind regards

Ignacio
Find all posts by this user
Quote this message in a reply
05-15-2015, 12:56 PM
Post: #2
RE: HP41C keyboard label remove
My first impulse would be to put an overlay over the marred label.

Am I missing something ??

(it's early here and I'm not too perky yet, LOL)

2speed HP41CX,int2XMEM+ZEN, HPIL+DEVEL, HPIL+X/IO, I/R, 82143, 82163, 82162 -25,35,45,55,65,67,70,80
Find all posts by this user
Quote this message in a reply
05-16-2015, 06:41 AM (This post was last modified: 05-19-2015 11:03 AM by Ángel Martin.)
Post: #3
RE: HP41C keyboard label remove
(05-15-2015 12:56 PM)TASP Wrote:  My first impulse would be to put an overlay over the marred label.

I had the same though - and a few sticker overlays that could fit the bill. Mind you, not for the standard keyboard but the SandMath, and 41Z; thus you'd have that looking at you permanently which can be perhaps overwhelming and probably not what you want.

"To live or die by your own sword one must first learn to wield it aptly."
Find all posts by this user
Quote this message in a reply
05-19-2015, 09:07 AM
Post: #4
RE: HP41C keyboard label remove
Hi,
just to report that I have done it, with the help of a hairdryer.
It looks acceptable, but it has some bends and marks that are very difficult to avoid.

Thanks a kind regard

Ignacio
Find all posts by this user
Quote this message in a reply
05-23-2015, 01:30 PM
Post: #5
RE: HP41C keyboard label remove
Ignacio, good luck with it!
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)