HP Forums
<-ENG ENG-> 2 - Printable Version

+- HP Forums (https://www.hpmuseum.org/forum)
+-- Forum: HP Software Libraries (/forum-10.html)
+--- Forum: HP Prime Software Library (/forum-15.html)
+--- Thread: <-ENG ENG-> 2 (/thread-9875.html)



<-ENG ENG-> 2 - BERNARD MICHAUD - 01-07-2018 11:12 PM

EngSci Update A program that handles Engineering or Scientific adjustment. You can use the result of a calculation on the stack(0.0078), [copy] it to the command line then store it in the variable N, start the program and select option 1 or 2. Variable N will appear in input box #:[0.0078 ] EEX remains '0'.
1 Engineering,
2 Scientific
.
Press Enter and the info is transferred to the Graphic Screen. From there you press either the top or bottom buttons on the circular Navigation key to increase or decrease the Exponent.
Notice that the Stack number is limited to 11 Digits if you continue pressing up or downthe # will go into Sci notation but the result is still accurate. To Exit press Esc key.

BM

Added note: SI prefix added to EEX


RE: <-ENG ENG-> 2 - math7 - 09-11-2018 07:17 AM

Hi, Bernard, your program is very good. I would like to know if it would be possible to add an option to go from a very high exponent at a time to the original number that was had, or vice versa, from a very low exponent to the original number and not having to press the up key and the from below once at a time? That is, if I want to go from 5.56 x 10 ^ 24 and return to the original number, do not have to press so many keys? Thank you.