HP Forums

Hi, I have purchaded a hp 41C with the assurance that it is upgradable to a Sy 41CL.
I open my 41C to verify if the connector for the Nut board is as the one
in the sy41cl.pdf manual, and I am not sure that it is OK.
My 41C has the serial number 2148S42321.
I maked an attachement for a photo of the connector inside my 41C.
Thank you so much for all your help!!!
[attachment=6143]

(07-20-2018 07:15 AM)Podalirius Wrote: [ -> ]Hi, I have purchaded a hp 41C with the assurance that it is upgradable to a Sy 41CL.
I open my 41C to verify if the connector for the Nut board is as the one
in the sy41cl.pdf manual, and I am not sure that it is OK.
My 41C has the serial number 2148S42321.
I maked an attachement for a photo of the connector inside my 41C.
Thank you so much for all your help!!!

Yes, this should work OK for a CL upgrade, assuming it is working properly as a 41C now. This 41C has had its lower posts recently repaired using parts from "The Calculator Store"

Hi, Thank you very much for your help.
The 41C is working fine. Is repaired by The Calculator Store
and I purchased it form this site.