The Museum of HP Calculators

HP Forum Archive 21

[ Return to Index | Top of Index ]

Help: HP9825A Power Up Issue
Message #1 Posted by John M (Ottawa) on 15 Sept 2012, 5:12 p.m.

I acquired HP9825A from a friend and I am trying to bring it to life. It was in storage for many years and is in good condition. When I power up, I get flashing display - alternating between cursor and full-segment display (all pixels on). Pressing any key results in flashing to change between "error 01" and full-segment display. Pressing RESET clears the error code but returns to previous flashing state. There are no ROM cards or interfaces installed. I checked the Operating System module is clean and appears to be properly seated. Any help is appreciated.

      
Re: Help: HP9825A Power Up Issue
Message #2 Posted by Steve Leibson on 17 Sept 2012, 3:20 a.m.,
in response to message #1 by John M (Ottawa)

Error 01 is an "unexpected peripheral interrupt." A basic 9825 has three peripherals: keyboard, display, tape. Check the keyboard for a stuck-down key. The "enter" key was used the most, so check it first. If this is an earlier model with the clicky calculator-style keys (as opposed to the later computer-style keys) then one of the key contacts may have stuck down.

      
Re: Help: HP9825A Power Up Issue
Message #3 Posted by Tony Duell on 18 Sept 2012, 4:43 a.m.,
in response to message #1 by John M (Ottawa)

My immediate thought is that it's power supply trouble. Given the machine has been in storage, I would suspect dried-up capacitors causing excessive ripple on the supply lines. A machine with supply lines that are dipping below the expected value twice every mains cycle is going to behave oddly :-)

You can get the service manual ('boardswapper guide') and schematics from the Australian museum site. Start by using a 'scope to check every supply line for the correct voltage and lack of ripple. If you find any problems, check the electrolytic capacitors on the PSU board.

      
Re: Help: HP9825A Power Up Issue
Message #4 Posted by John M (Ottawa) on 19 Sept 2012, 1:54 p.m.,
in response to message #1 by John M (Ottawa)

Thank you for the suggestions.

1. Steve - No stuck keys. 2. Tony - Power supplies voltages look OK. Not much ripple on the few lines I checked. (Thanks for the schematics).

Upon further experimentation, the 9825A works OK with a tape inserted in the tape drive. I was initially reluctant to insert a tape since the drive's capstan wheel is obviously gummy. But when I insert a tape, the "error 01" resets. Eject the tape - I get the error 01 when any key is pressed.

Alas, now my big decision - rebuild the tape drive or not?

            
Re: Help: HP9825A Power Up Issue
Message #5 Posted by Dave Shaffer (Arizona) on 19 Sept 2012, 4:33 p.m.,
in response to message #4 by John M (Ottawa)

Quote:
rebuild the tape drive or not?

For the moment, can't you hot wire a switch somewhere (mechanical or electrical "tape detect" it would seem)?


[ Return to Index | Top of Index ]

Go back to the main exhibit hall