HP Forum Archive 21

[ Return to Index | Top of Index ]

Classic (HP-67) charger issues revisited Message #1 Posted by Matt Agajanian on 19 May 2012, 9:07 p.m. Hello all, I apologise for bringing up the repeat but, here it goes. I'm not certain why this is happening. Seven hours after I've plugged in the 67 for a recharge, when I try to operate the 67 while it's charging, it will not light up. The charger and the 67 by the battery door are warm. This does not happen when I plug in my other classics (35, 45, 55) to recharge. What is happening? Could the 67 be charging regardless of the operation of the 67 off the adapter? Any suggestions? Edited: 19 May 2012, 9:08 p.m.

Re: Classic (HP-67) charger issues revisited Message #2 Posted by LHH on 20 May 2012, 12:04 a.m., in response to message #1 by Matt Agajanian Does the 67 run on these batteries? If not then there's probably a bad cell(s) in the pack. If so a higher degree of knowledge than mine about the 67 will be needed. LHH

Re: Classic (HP-67) charger issues revisited Message #3 Posted by Matt Agajanian on 20 May 2012, 9:48 a.m., in response to message #2 by LHH Hello there. Yup! The 67 (and my other Classics, too) is ready to run a marathon with those batteries.

Re: Classic (HP-67) charger issues revisited Message #4 Posted by Randy on 20 May 2012, 7:43 a.m., in response to message #1 by Matt Agajanian Does the 67 operate as soon as you plug in the charger? Do you get the same (bad) behavior when using that specific battery and charger combination in another calculator?

Re: Classic (HP-67) charger issues revisited Message #5 Posted by Matt Agajanian on 20 May 2012, 9:57 a.m., in response to message #4 by Randy Now THAT was what I discovered. My 67 just came back from the hospital after having surgery on the card reader. So, it had been a few weeks since I charged the 67. Also, as I have a fleet of other Classics, I also have that same amount of chargers. In this case, I must've picked up the flaky charger instead of one of the good ones. Yes, after I made this blunder, I realised that I hadn't quarantined the faulty charger when I first used it. Now that I know which adapter is non-functional, I've isolated it from the lineup. So, with a functional charger fished out, I am now successfully charging my 67. Thanks for the help.

Re: Classic (HP-67) charger issues revisited Message #6 Posted by aurelio on 20 May 2012, 11:53 a.m., in response to message #5 by Matt Agajanian Great, you found the guilty!

Re: Classic (HP-67) charger issues revisited Message #7 Posted by Matt Agajanian on 20 May 2012, 10:50 p.m., in response to message #6 by aurelio Well, I'll give it a fair shake and send it to a rest home.

[ Return to Index | Top of Index ]

Go back to the main exhibit hall