HP Forum Archive 21

[ Return to Index | Top of Index ]

WP 34S bug report Message #1 Posted by Harald on 3 Mar 2012, 1:56 p.m. Pressing h CAT works fine with no program entered. Once I enter a little test program (just a few lines are enough) pressing h CAT results in the calculator to crash. Only the reset but helps. I am currently running revison 2495. Harald.

Re: WP 34S bug report Message #2 Posted by Marcus von Cube, Germany on 3 Mar 2012, 2:36 p.m., in response to message #1 by Harald That should definitely not happen. Some questions: Does your program in RAM show an END statement? It should but there might be situations where the statement gets lost. Does your program in RAM have a long label of the form LBL'xyz'? Did you load the library onto your calculator? Edit: Your version is a bit old and I remember to have fixed an issue in the label browser not too recently. Please update your device! Edited: 3 Mar 2012, 2:44 p.m.

Re: WP 34S bug report Message #3 Posted by Harald on 3 Mar 2012, 2:48 p.m., in response to message #2 by Marcus von Cube, Germany I flashed the calculator with the "_full" image, so I do have the libraries. I reduced the program to a very short: LBL A RCL 00 END So the end satemant is there. The problem occurs every time I try.

Re: WP 34S bug report Message #4 Posted by Marcus von Cube, Germany on 3 Mar 2012, 3:01 p.m., in response to message #3 by Harald It must be the old firmware. If you put a LBL'ABC' in the first step it will work. Please update your device!

Re: WP 34S bug report Message #5 Posted by Harald on 3 Mar 2012, 3:13 p.m., in response to message #4 by Marcus von Cube, Germany Yes, it works in revison 2628. Sorry for not updating before posting this. Cheers, Harald

[ Return to Index | Top of Index ]

Go back to the main exhibit hall