|WP34S V3 : STATUS questions|
Message #1 Posted by Miguel Toro on 29 Dec 2011, 5:46 p.m.
Hello WP34s Team,
Today I finally made the jump to version 3.0. Reading about the new memory management I tried the STATUS command to see the new information available. So now I have some questions and a comment:
1 - What is exactly the first information shown? It says Steps: 531, FL. 2046
2 - Why is there a difference between the steps shown by STATUS and the steps available when I switch to program mode?
STATUS: 531, Program mode: 525.
3 - I think there is something wrong using [arrow down] and [arrow up] while in STATUS: when viewing the information with [arrow down] and after seeing the registers available, the calculator cycles through flags and stack registers only, but when using [arrow up], it cycles through the entire information.
Well that is all for now,
As always, thank you for this magnificent device and regards,
Note: I am using revision 2092.
Edited: 29 Dec 2011, 5:48 p.m.