HP Forum Archive 17

[ Return to Index | Top of Index ]

EMU41 2.4 ALPHA issue Message #1 Posted by Egan Ford on 18 June 2007, 9:18 p.m. I am new to EMU41 (I am using it for it's HP-IL support). When I press F4 for ALPHA I am only able to enter a,b,c,d,e, anything else is *. It is as if all input is 41-shifted. F8-F4 (i.e. XEQ-ALPHA) does not have this problem. Has anyone else seen this? Thanks.

Re: EMU41 2.4 ALPHA issue Message #2 Posted by Howard Owen on 18 June 2007, 10:42 p.m., in response to message #1 by Egan Ford Are you using the CX ROMs? Do you have the CCD module loaded? The CX ROMs are needed to have all the lowercase characters in ROM,of course. And the CCD ROM only does full lower case when USER mode is on. Regards, Howard

Re: EMU41 2.4 ALPHA issue Message #3 Posted by Egan Ford on 18 June 2007, 11:36 p.m., in response to message #2 by Howard Owen Thanks. Unloading CCD fixed it. However, I didn't have USER mode enable. Thanks again.

Re: EMU41 2.4 ALPHA issue Message #4 Posted by Raymond Del Tondo on 20 June 2007, 12:18 a.m., in response to message #3 by Egan Ford Actually, the extended ALPHA mode of the CCD module is active when USER is OFF. Apart from that, the CCD module and the CCD OS/X greatly improve the usability of the HP-41. Many user interface related things are much easier with the CCD OS Xtensions. My minimal config is CX/CY + CCD OS/X, of course;-) HTH Raymond

[ Return to Index | Top of Index ]

Go back to the main exhibit hall